Products

Carbide Micro Square Nose End Mill, Uncoated (Bright) Finish, 30 Deg Helix, 4 Flutes, 1.5" Overall Length, 1/16" Cutting Diameter, 1/8" Shank Diameter

Keywords :

Router Bit / End Mills Carbide / Milling Cutter


  • Hits : 33
  • Company : Capital Tools Group Co. Limited
  • Telephone : +86 13510300970
Contact Us

Product Details

Contact Us

Five Advantages Of Products

  • -Suitable for machining steel, hardened steel, steel alloys, stainless steel, cast iron, copper, brass, bronze, aluminum, and aluminum alloys
  • -Four flutes produce a better finish than fewer flutes
  • -Carbide can run at higher speeds than high-speed or cobalt steel, resisting wear and high cutting temperatures
  • -Uncoated (bright) tools have no additional surface treatment or coating for use on a broad range of materials
  • -Center-cutting design allows the end mill to plunge into material like a drill bit while also performing conventional surface milling

Product Details

 uncoated carbide square nose end mill has four flutes, a 30-degree helix, and a center-cutting design for machining steel, hardened steel, steel alloys, stainless steel, cast iron, copper, brass, bronze, aluminum, and aluminum alloys. Four flutes produce a better finish than fewer flutes. The 30-degree helix angle supports general-purpose applications. It balances lower angles’ strong cutting edge for difficult-to-machine materials with higher angles’ increased cutting action. The tool’s square end creates sharp, unrounded cuts. The center-cutting design has cutting teeth at the end of the tool, so it can be fed into the workpiece like a drill bit.

Carbide is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and providing longer tool life. This tool has no coating or surface treatment. Cutting diameter tolerance is + 0.000 to - 0.002". The round shank accommodates a range of tool holders.

End mills are designed to remove material and create multi-dimensional shapes and profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. The number of flutes can range from two to eight. Two-flute designs offer the most efficient chip removal, but more flutes provide a smoother finish. The shank is the end of the tool held in place by a tool holder or machine. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts.


Capital Tools Group Co. Limited

Contact Person: Jennifer Chueng

Post: Jennifer@capitaltoolsgroup.com

Telephone: +86 13510300970

Landline: +86 755 83125062

Company Address: Floor 7 Building B,#1 Huafeng Industrial Park,Bao’an District, Shenzhen China.

Website: www.capitaltoolsgroup.com

Previous: 1/8" Shank Dia. Carbide Flat Nose...

Next: Carbide Square Nose End Mill, TIA...

Inquiry :

Inquiry
Shrink